Fault Code 32-1984

Synopsis

Notes: For 1984 models only

Description: Power loss or limited lamp or circuit failure
Power loss light: Off
Limp-in mode: None

Possible Causes

Dead bulb - Replace bulb if neccessary.

Bad connection or wiring - Check the wiring and connections between the bulb and the logic module (or SMEC). Clean and regrease any corroded connectors with dielectric grease and repair any shorts.

Diagnostic Method

Trigger Parameters

- Near 0V or near 12V not detected when the lamp is turned on or off, respectively

Results If Component Fails

Fault code 32 is stored.

Return to the Fault Codes Page

This page is maintained by Russell W. Knize and was last updated 08/28/98. Comments? Questions? Send email.