output indicates rich too long
Power loss light: Off
Limp-in mode: Engine allowed to run rich, but prevented from running lean
Bad connection or wiring - Check the wiring and connections between the sensor and the logic module (or SMEC). Clean and regrease any corroded connectors with dielectric grease and repair any shorts. Look for melted wire insulation near the exhaust manifold. A shorted connection to any positive source will cause this fault code.
High fuel rail pressure - See the Diagnosing
Your Fuel System page.
|Return to the Fault Codes Page|
This page is maintained by Russell W. Knize and was last updated 08/28/98. Comments? Questions? Send email.
Copyright © 1996-2003 Russ W. Knize