Fault Code 51-1984


Notes:  For 1984 models only

Description:  Oxygen sensor output indicates lean or rich too long
Power loss light:  Off
Limp-in mode:  Engine allowed to run rich, but prevented from running lean

Possible Causes

Bad oxygen sensor - Replace the sensor which is located on the turbo housing near the down pipe (for turbo) or on the down pipe near the exhaust manifold.

Bad connection or wiring - Check the wiring and connections between the sensor and the logic module (or SMEC).  Clean and regrease any corroded connectors with dielectric grease and repair any shorts.  Look for melted wire insulation near the exhaust manifold.  A shorted connection to ground or any positive source will cause this fault code.

Low or high fuel rail pressure - See the Diagnosing Your Fuel System page.

Diagnostic Method

Trigger Parameters

- In closed-loop
- Sensor output indicates lean or rich for more than 121 seconds

Results If Component Fails

A fault code 51 is stored, the circuit stays in closed-loop, and the logic module will still monitor the oxygen sensor signal.  If the condition persists for four times what it took to set the code, the logic module will allow the engine to run rich, but prevent it from running lean.
Return to the Fault Codes Page


This page is maintained by Russell W. Knize and was last updated 08/28/98. Comments? Questions? Send email.

Copyright © 1996-2003 Russ W. Knize