Fault Code 42

Synopsis

Description: ASD (Automatic ShutDown) relay circuit is open or shorted
Power loss light: Off
Limp-in mode: None

Possible Causes

Blown fusible link to power module (or SMEC) - Check the only white fusible link (may look grey if dirty) by tugging on it. A good link will feel solid while a blown link will stretch like a rubber band. It is the white link on the two-link circuit (not the four or five link circuit). This link supplies power to the ASD relay and the voltage sense input on the logic module (may be accompanied by a code 16). See the Fusible Links page for more details.

Bad connection or wiring - Check the wiring and connections between the ASD relay and the logic module. Clean and regrease any corroded connectors with dielectric grease and repair any shorts.

ASD relay failure - Disconnect the relay, apply 12V to the relay coil, and check the contacts

Diagnostic Method

Trigger Parameters

- Near 0V or near 12V not detected when the relay is turned on or off, respectively

- 12V not detected at output of ASD relay

Results If Component Fails

Fault code 42 is stored.

Return to the Fault Codes Page

This page is maintained by Russell W. Knize and was last updated 08/28/98. Comments? Questions? Send email.