Fault Code 37
solenoid circuit is open or shorted
Power loss light: Off
Limp-in mode: None
Bad connection or wiring - Check the wiring and connections between
the logic module and the solenoid. Clean and regrease any corroded
connectors with dielectric grease and repair any shorts.
Bad solenoid - The solenoid is located in the right, front fender
next to one to three other solenoids. See the Understanding
Solenoids page for information about how to test and repair solenoids.
- Near 0V or near 12V not detected when the solenoid is turned on or off,
Results If Component Fails
Fault code 37 is stored.
This page is maintained by Russell W. Knize and was last updated 08/28/98.
Comments? Questions? Send email.
Copyright © 1996-2003 Russ W. Knize