Fault Code 35

Synopsis

Description: Radiator fan relay circuit is open or shorted
Power loss light: Off
Limp-in mode: None

Possible Causes

Bad connection or wiring - Check the wiring and connections between the logic module and the relay. Clean and regrease any corroded connectors with dielectric grease and repair any shorts.

Bad relay - Disconnect the relay and apply 12V across the coil terminals (between the white wire and either of the other two terminals on the small connector). You should hear a click for either of the two termials and the connection between the grey wire and the other two terminals of the large connector should be shorted.

Diagnostic Method

Trigger Parameters

- Near 0V or near 12V not detected when the relay is turned on or off, respectively

Results If Component Fails

Fault code 35 is stored.

Return to the Fault Codes Page

This page is maintained by Russell W. Knize and was last updated 08/28/98. Comments? Questions? Send email.