sensor signal out of range
Power loss light: On
Limp-in mode: Charge temperature sensor as an indication of the coolant temperature
Bad connection or wiring - Check the wiring and connections between
the sensor and the logic module (or SMEC). Clean and regrease any
corroded connectors with dielectric grease. You may have disconnected
the sensor if you recently set the base ignition timing.
|Return to the Fault Codes Page|
This page is maintained by Russell W. Knize and was last updated 08/28/98. Comments? Questions? Send email.
Copyright © 1996-2003 Russ W. Knize